Bending a PVC pipe is easier than you thought. Just follow the below steps and you’re good to go. In the following sections, we will discuss this in more detail, giving you a comprehensive insight into how you can complete the project without using any tools. Additionally, we’ve also listed some use-cases and safety tips that’ll probably help you handle this project better.
Five ways to bend PVC pipes without any tools
Well, this is fairly simple. Just follow either of the following five methods and you’re good to go from there.
This is one of the most common ways when it comes to bending PVC pipes. For this, take some sand and first fill it more than halfway into your PVC pipe. Now transfer the same sand to an oven-safe tray and get it heated for five to six minutes in a preheated oven (283-285 degrees Celsius).
As the sand heats up, mark both the sides of your PVC pipe with tape. Keep an eight inches gap while marking the tape. We are recommending this marking for easier bending of your pipes. Once the sand is sufficiently heated, transfer it to the pipe and you will soon witness the external part of the pipe getting pliable.
Once it is soft enough for bending, start bending the pipe according to your previous markings. Allow it to cool for the next couple of minutes and you are good to go.
If you do not have an oven at home, you can heat the sand in a gas oven and repeat the previous steps. This is extremely simple and because you already know what to do, it wouldn’t take you much time to get started.
However, when using a gas oven, make sure the heat is controlled and the sand isn’t fully burnt at any point. This will not work in your favor so avoid this situation entirely.
Another simple way to bend your pipe is by using boiling water. Simply steam some water in a container and once the water is warm enough, take either end of the pipe and bring it close to the container. The positioning should be such that steam conveniently passes through the pipe.
Once the steam starts passing, your pipe will get softer, and you can mold it conveniently. However, even before you do that, wait out a couple of minutes because you don’t want the pipe suddenly hard halfway into your task.
Also, make sure you wear gloves because you would be directly holding the hot pipe. This will prevent burns and accidents.
This is the most common method when it comes to bending PVC pipes. The process is simple. Just mark your pipes on both sides with tape keeping a gap of 8 inches. This will help you bend the pipe in a better and more consistent fashion. Next, get your hairdryer ready and make sure it is heated up well.
Turn the switch on and keeping a distance of three to four inches, blow your dryer around the marked edges. After a point of time, the PVC will start getting soft enabling you to bend it in your desired manner.
This process works the same way as the hairdryer. So, if you do not have a hairdryer handy, you can repeat the same process with a heat gun. It is simple and will barely take you a couple of minutes to complete. As with the previous step, make sure you are safe and operate the heat gun only when your hand is fully dry.
If you are handling a PVC pipe for the first time, you might want to go through some safety tips even before you start the project. This will help you understand the nuances of the project better and also limit/prevent the possibility of potential accidents. Here are some of the tips you might want to follow:
- First, always wear gloves while holding the hot PVC pipe, hairdryer, heat gun, oven tray, sand, and basically any other heated object
- If you are using the hairdryer or the heat gun method, avoid holding the gadgets with wet hands
- Make sure your electrical devices work properly and are connected safely to the main power outlet
If done safely, bending PVC pipes is not as intimidating it sounds. The process is simple and because we listed multiple methods, we are certain you will find your perfect fit among the listed options. Just bear the safety tips in mind and always wear mittens or gloves while holding heated objects. Once you follow these simple parameters, the process is simple, hassle-free and also incredibly cost-effective,